October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.
Compressor Isolation Method: Installation
- Position compressor on engine, install compressor clutch using new retaining bolt and washer (energize clutch to hold shaft while tightening nut).
- Make necessary compressor oil level check and add oil if necessary.
NOTE:
See Compressor Oil Check in this Section.
- Remove service valve caps and shipping plugs from compressor valve ports and immediately install service valves on compressor using new "O" rings.
- Without disturbing service valve positions (front-seated), use vacuum pump to evacuate compressor, then close vacuum pump valve and stop the pump.
- Back-seat service valves to cut compressor into the system, operate system for 5 minutes at fast idle.
- Leak test compressor connections and compressor seal.
- Recheck compressor oil level, adding or removing oil as necessary for correct oil level.