LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Freightliner >> 2005 >> Sprinter 3500 L5-2.7L DSL Turbo >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Relays and Modules - Computers and Control Systems >> Engine Control Module >> Diagrams >> Diagram Information and Instructions >> Connector, Ground and Splice Information
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Connector, Ground and Splice Information






CONNECTOR, GROUND AND SPLICE INFORMATION


CAUTION: Not all connectors are serviced. Some connectors are serviced only with a harness. A typical example might be the Supplemental Restraint System connectors. Always check parts availability before attempting a repair.


IDENTIFICATION


In-line connectors are identified by a number, as follows:

- In-line connectors located in the engine compartment are C100 series numbers.

- In-line connectors located in the instrument panel area are C200 series numbers.

- In-line connectors located in the body are C300 series numbers.

- Jumper harness connectors are C400 series numbers.

- Grounds and ground connectors are identified with a "G" and follow the same series numbering as the in-line connectors.

- Splices are identified with an "S" and follow the same series numbering as the in-line connectors. In addition, S001-S099 numbers are located in the engine compartment.

- Component connectors are identified by the component name instead of a number. Multiple connectors on a component use a C1, C2, etc. identifier.


LOCATIONS


Section 8W-91 contains connector/ground/splice location illustrations. The illustrations contain the connector name (or number)/ground number/splice number and component identification. Connector/ground/splice location charts in section 8W-91 reference the figure numbers of the illustrations.

The abbreviation T/O is used in the component location section to indicate a point in which the wiring harness branches out to a component. The abbreviation N/S means Not Shown in the illustrations

scientia non olet · About LEMON Manuals