Radio Transceiver Module (RTM): Installation

NOTE: Obtain the specified adhesive commercially. Depending on the headliner and optional wire harness(es), the purchase of multiple tubes is suggested.
1. Position the RTM onto the new headliner, making sure the harness has enough length to connect to the RTM.
2. Apply the adhesive in the same location as the factory installed adhesive on the RTM to avoid any NVH concern(s).
  Material
  
  : Urethane Adhesive
To install, reverse the removal procedure.
Using the previous diagnostic scan tool session, carry out the PMI procedure for the RTM.