LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2024 >> E-Transit Van Cargo Extended >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (All-Wheel Drive (AWD) Systems) >> Removal And Installation >> All-Wheel Drive (AWD) Module >> Removal
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

All-Wheel Drive (AWD) Module: Removal

WARNING: This page is about a different car, the 2024 Ford Bronco Sport. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Removal steps in this procedure may contain installation details.
NOTE: If installing a new all-wheel drive module, it is necessary to upload the module configuration information to the scan tool prior to removing the module. This information must be downloaded into the new all-wheel drive module after installation. Using a diagnostic scan tool, begin the PMI process for the all-wheel drive module following the onscreen instructions.
  1. Remove the passenger seat. Refer to: Front Seat .
  2. Remove the lower B-pillar trim panel only. Refer to: B-Pillar Trim Panel .
  3. Release the push pins and remove the RH insulation panel.
    GFD834669Courtesy of FORD MOTOR COMPANY
  4. Release the clips and remove the access cover.
    GFD834670Courtesy of FORD MOTOR COMPANY
  5. Remove the push pins and position aside the floor carpet aside.
    GFD834671Courtesy of FORD MOTOR COMPANY
    • Detach the wiring harness retainer from the HVAC duct.

    • Remove the push pins and the HVAC duct.

    GFD834672Courtesy of FORD MOTOR COMPANY
    1. Release the tab from the connector.
    2. Disconnect the electrical connector from the module.
    GFD834673Courtesy of FORD MOTOR COMPANY
  8. Remove the nuts and the AWD module.

    Torque: 10 Nm

GFD834674Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals