July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Programmable Module Installation (PMI) Using the Integrated Diagnostic System (IDS) When the Original Module is Available

NOTE: Following module installation, some modules require a separate learning procedure be carried out. For adaptive learning and calibration instructions, refer to the specific module removal and installation procedures.

1.

Connect the Integrated Diagnostic System (IDS) and identify the vehicle as normal.

2.

From the Toolbox icon, select Module Programming and press the check mark.

3.

Select Programmable Module Installation.

4.

Select the module that is being replaced.

5.

Follow the on-screen instructions, turn the ignition key to the OFF position, and press the check mark.

6.

Install the new module and press the check mark.

7.

Follow the on-screen instructions, turn the ignition key to the ON position, and press the check mark.

8.

The IDS downloads the data into the new module and displays Module Configuration Complete.

9.

Test module for correct operation.