July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Powertrain Control Module (PCM): Installation

1.

Connect the PCM electrical connectors.

GFD48643

Courtesy of FORD MOTOR COMPANY

2.

Install the PCM and the retainers.

GFD48642

Courtesy of FORD MOTOR COMPANY

3.

Install the PCM cover and the retainers.
Torque: 27 lb.in (3 Nm)

GFD48641

Courtesy of FORD MOTOR COMPANY

4.

Install the LH fender splash shield. Refer to: Fender Splash Shield .

5.

NOTE: This step is only necessary when installing a new component.

Upload the module information from the diagnostic tool using the Programmable Modules Installation routine. Refer to: Module Configuration - System Operation and Component Description . Use the General Equipment: Ford Diagnostic Equipment

6.
- Reprogram the PATS. Carry out the Parameter Reset procedure. For vehicles without Intelligent Access (IA). Refer to: Passive Anti-Theft System (PATS) Parameter Reset .
- Reprogram the PATS. Carry out the Parameter Reset procedure. For vehicles with Intelligent Access (IA). Refer to: Passive Anti-Theft System (PATS) Parameter Reset .

7.

After completing the repairs, perform the Misfire Monitor Neutral Profile Correction procedure.