Inspection and Verification

This information provides step-by-step module configuration procedures. Carry out PROGRAMMABLE MODULE INSTALLATION (PMI) when another workshop article directs to carry out configuration or when DTCs from the list below are present:

NOTE: Some modules on this vehicle utilize a 5-character DTC followed by a 2-character failure-type code. The failure-type code provides information about specific fault conditions such as opens, or shorts to ground. Continuous Memory DTCs have an additional 2-character DTC status code suffix to assist in determining DTC history.

DTC CHART

DTC	Description	Source	Action
B2477	Module Configuration Failure	ABS module Audio Front Control Module (ACM) (Early build) Generic Electronic Module (GEM) Instrument Cluster (IC) Parking Aid Module (PAM) Restraints Control Module (RCM) Tire Pressure Monitoring System (TPMS) module	CARRY OUT Programmable Module Installation (PMI). REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
P0602:00	Powertrain Control Module Programming Error: No Sub Type Information	PCM	CARRY OUT PMI. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
P0605:00	Internal Control Module Read Only Memory (ROM) Error: No Sub Type Information	PCM	CARRY OUT PMI. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
P1635:00	Tire/Axle Out Of Acceptable Range: No Sub Type Information	PCM	CARRY OUT PMI. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
P1639:00	Vehicle ID Block Corrupted, Not Programmed: No Sub Type Information	PCM	CARRY OUT PMI. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
U0300:00	Internal Control Module Software Incompatibility: No Sub Type Information	PCM	CARRY OUT PMI. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
U2050	No Application Present	ABS module IC Occupant Classification System Module (OCSM) RCM TPMS module	CARRY OUT PMI. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
U2051	One or More Calibration Files Missing / Corrupt	RCM OCSM	CARRY OUT PMI. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
U2100:00	Initial Configuration Not Complete: No Sub Type Information	Accessory Protocol Interface Module (APIM)	CARRY OUT PMI. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
U2101:00	Control Module Configuration Incompatible: No Sub Type Information	APIM	CARRY OUT PMI. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .
U2202:00	Invalid Configuration Data Received: No Sub Type Information	ABS module with stability control	CARRY OUT PMI. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .