LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2013 >> Fiesta Titanium, 4D Hatchback, Automatic DCT Trans >> Repair and Diagnosis >> Steering >> Power Steering >> Steering System >> Interactive Diagnostics >> Pinpoint Tests >> Pinpoint Test D: DTC U3000: Control Module - Actuator Stuck Open >> Normal Operation
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Normal Operation

When the ignition is turned ON a relay inside the power steering control module (PSCM) is energized, which sends power to other portions of the module. The PSCM monitors this relay output and will set a DTC if output is not detected.

NOTE: If a damaged bellows boot(s) was discovered during Inspection and Verification and this pinpoint test DOES NOT lead to the installation of a new EPAS gear or bellows boot(s), then go to Pinpoint Test K: Damaged Steering Gear Bellows Boots  to address the damaged boot(s) before returning the vehicle to the customer.
  1. D1: CHECK FOR RETURNING DTCS 

    Clear the PSCM DTCs.

    Cycle the ignition to OFF and then back to RUN.

    Press Read Vehicle Information button to retrieve DTC s from the vehicle.

    NOTE: DTCs may be displayed from previous diagnostic actions.
  2. D2: ATTEMPT TO RECREATE THE FAULT CONDITIONS 

    Park the vehicle in a cold or frosty environment and allow it to remain there overnight.

    NOTE: Do not allow the vehicle to warm up before carrying out the PSCM self-test.

    Ignition ON, engine OFF.

    Press Read Vehicle Information button to retrieve DTC s from the vehicle.

    NOTE: DTCs may be displayed from previous diagnostic actions.
scientia non olet · About LEMON Manuals