Instrument Cluster Illumination And Panel Illumination DTCS: BCM
RELATED MODULE DTC CHART - BCM
| DTC | Description | Action |
|---|---|---|
| B1249:12 | Start Button Illumination: Circuit Short to Battery | GO to PINPOINT TEST D . |
| B1249:14 | Start Button Illumination: Circuit Short to Ground or Open | GO to PINPOINT TEST D . |
| U1000:00 | Solid State Driver Protection Active: No Sub Type Information | The BCM has temporarily disabled an output because an excessive current draw exists (such as a short to ground). When the is DTC is stored in the BCM, the illumination output driver is disabled until the cause of the excessive current draw has been corrected and a successful self-test has been performed. ADDRESS all other BCM first. After the cause of the excessive current draw has been corrected, CLEAR the DTCs and PERFORM the self-test. |
| U2010:11 | Switch Illumination: Circuit Short to Ground | GO to PINPOINT TEST A . |
| U2010:15 | Switch Illumination: Circuit Short to Battery or Open | If one or more hardwired illumination source is inoperative, GO to PINPOINT TEST A . If one or more hardwired illumination source is always on, GO to PINPOINT TEST G . |
| U3000:49 | Control Module: Internal Electronic Failure | The BCM has permanently disabled an output because an excessive current draw exists (such as a short to ground) that has exceeded the limits of what the BCM can withstand. ADDRESS all other BCM DTCs first. After the cause of the excessive current draw has been corrected, INSTALL a new BCM. REFER to MULTIFUNCTION ELECTRONIC MODULES . |
| All other DTCs | - | REFER to MULTIFUNCTION ELECTRONIC MODULES . |