Front Controls/Display Interface Module (FCDIM): Removal
WARNING: This page is about a different car, the 2014 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
-
NOTE: If installing a new module, it is necessary to upload the module configuration information to the scan tool prior to removing the module. This information must be downloaded into the new module after installation.
Upload the FCDIM configuration information to the scan tool by following the scan tool on screen instructions.
- Remove the FCIM . Refer to FRONT CONTROLS INTERFACE MODULE (FCIM)
- Remove the 4 screws and the FCDIM
.
- Disconnect the electrical connector.
- To install, tighten to 2 Nm (18 lb-in).