ABS With AdvanceTrac®: Notes
WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
The ABS with AdvanceTrac® consists of the following components:
- ABS module - attached to the Hydraulic Control Unit (HCU), but can be serviced separately.
- Front wheel speed sensors - one sensor is located in each front wheel knuckle. The sensors are serviced separately from the knuckle.
- Front wheel speed sensor tone rings - one tone ring is located on each front wheel hub and is serviced separately from the wheel hub.
- HCU - which contains several valves (inlet, outlet, isolation and dump) and the hydraulic pump motor. It is mounted in the LF corner of the engine compartment and can be serviced separately.
- Rear wheel speed sensors - one sensor is located on each end of the rear axle housing. The sensors are serviced separately from the axle housing.
- Rear wheel speed sensor tone rings - one tone ring is located on each axle shaft and is serviced separately from the axle shaft.
- Restraints Control Module (RCM) - located under the rear of the front floor console and contains the yaw rate and lateral accelerometer sensors.
- Power Steering Control Module (PSCM) located in the steering gear, sends steering angle and rotation information to the ABS module.
- Stability/traction control switch - is part of the hazard flasher switch assembly.