LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2012 >> Taurus SEL, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1079 (Electronic Engine Control System) >> Removal And Installation >> Knock Sensor (KS) >> Removal And Installation
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Removal And Installation

WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the thermostat housing. For additional information, refer to ENGINE COOLING .
  2. Remove the lower intake manifold. For additional information, refer to ENGINE - 3.5L .
  3. Remove the coolant tube.
    • Discard the O-ring.
  4. Disconnect the knock sensor (KS) electrical connector.
  5. Remove the 2 bolts and the KS.
    • To install, tighten to 20 Nm (15 lb-ft).
  6. To install, reverse the removal procedure.
    • Lubricate the new O-ring with clean engine coolant.
scientia non olet · About LEMON Manuals