October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.
Lumbar Assembly - Power: Installation
- Install the power lumbar in the following sequence.
- Squeeze the power lumbar retaining clip together and engage it into the backrest frame.
- Repeat for the power lumbar retaining clip on the other side.
- Connect the power lumbar motor electrical connector.
- Roll the backrest trim cover down and install the 3 first row hog rings.
Courtesy of FORD MOTOR CO.
- Roll the backrest trim cover all the way down and engage the lower J-clips.
- Make sure the side air bag module wire harness is routed out from the outboard side of the backrest before engaging the lower J-clips.
- Make sure the backrest feed wire harness is routed out from the inboard side of the backrest before engaging the lower J-clips.
- Attach the cushion side shield in the following sequence.
- Return all retaining clips back to the cushion side shield before attaching to the seat.
- Align the 4 cushion side shield clips to the seat and push in seating the clips.
- Install the screw at the front of the cushion side shield.
- Install the screw at the rear of the cushion side shield.
- Install the scrivet at the rear of the cushion side shield.
- Install the recliner cover in the following sequence.
- Return the barrel nut back to the seat before attaching to the seat.
- Slide the recliner cover post into the barrel nut on the seat.
- Install the screw at the rear of the recliner cover.
- Install the scrivet at the rear of the recliner cover.
- Install the front seat. For additional information, refer to SEAT - FRONT
.