Windshield Washer Reservoir: Service and Repair

Washer Reservoir





Removal and Installation

1. Remove the RH front fender splash shield.

2. Disconnect the washer pump electrical connector.

3. Drain the washer reservoir.

4. Disconnect the washer pump hoses.

5. Remove the bolt from the washer reservoir filler neck.
- To install, tighten to 9 Nm (80 lb-in).


6. Remove the washer reservoir nuts and the washer reservoir.
- To install, tighten to 9 Nm (80 lb-in).






7. NOTICE: Do not operate the washer pump prior to filling the washer reservoir. Failure to follow these instructions may result in premature pump failure.

To install, reverse the removal procedure.
- Fill the washer reservoir with windshield washer fluid.