Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

Remove the bolts and the accelerator control splash shield.

Fig 1: Identifying Accelerator Control Splash Shield & Bolts
Courtesy of FORD MOTOR CO.
- To install, tighten to 3 Nm (27 lb-in).
Disconnect the accelerator cable from the throttle lever.

Fig 2: Identifying Accelerator Cable Connection At Throttle Lever
Courtesy of FORD MOTOR CO.
Depress the tabs and remove the accelerator cable from the intake manifold.

Fig 3: Identifying Accelerator Cable Connection At Intake Manifold
Courtesy of FORD MOTOR CO.
Disconnect the accelerator cable from the accelerator pedal and shaft.

Fig 4: Disconnecting Accelerator Cable From Accelerator Pedal Shaft
Courtesy of FORD MOTOR CO.
Depress the tabs and remove the accelerator cable.

Fig 5: Identifying Accelerator Cable Lock Tabs
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.