Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Fiesta. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The IA keys need to be programmed into the new RFA module during ignition off. For additional information, refer to Key Programming Using Diagnostic Equipment in ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) . After the IA keys have been programmed into the new RFA module, the ignition must be turned to the ON mode in order to reset the parameters in the new RFA module and the PCM. For additional information, refer to Passive Anti-Theft System (PATS) Parameter Reset in ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .

Remove the passenger seat. For additional information, refer to SEATING .
Disconnect the 5 RFA module electrical connectors.
Remove the 2 bolts and the RFA module and bracket assembly.
- To install, tighten to 10 Nm (89 lb-in).
To install, reverse the removal procedure.
- Program the IA keys into the new RFA module. For additional information, refer to Key Programming Using Diagnostic Equipment in ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
- Carry out a Passive Anti-Theft System (PATS) parameter reset. For additional information, refer to Passive Anti-Theft System (PATS) Parameter Reset in ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .