Steering Column Control Module (SCCM)
STEERING COLUMN CONTROL MODULE DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Action |
|---|---|---|
| B1008: 09 | Wiper Mode Switch: Component Failure | INSTALL a new wiper/washer switch. REFER to WIPER/WASHER SWITCH . CLEAR the DTCs. REPEAT the self-test. |
| B1051: 09 | Front Washer Switch: Component Failure | INSTALL a new wiper/washer switch. REFER to WIPER/WASHER SWITCH . CLEAR the DTCs. REPEAT the self-test. |
| B1052: 09 | Rear Washer Switch: Component Failure | INSTALL a new wiper/washer switch. REFER to WIPER/WASHER SWITCH . CLEAR the DTCs. REPEAT the self-test. |
| B10AD:02 | Rain Sensor: General Signal Failure | If the rain sensitive wipers do not operate, GO to PINPOINT TEST G
. If the rain sensitive wipers operate correctly, disregard this DTC. |
| B10AD:08 | Rain Sensor: Bus Signal/Message Failure | If the windshield wipers only operate when high speed mode is selected, GO to PINPOINT TEST F
. If the rain sensitive wipers do not operate, GO to PINPOINT TEST G . |
| B10AD: 49 | Rain Sensor: Internal Electronic Failure | INSTALL a new rain sensor. REFER to RAIN SENSOR . CLEAR the DTCs. REPEAT the self-test. |
| B1131:02 | Wiper Motor Module: General Signal Failure | If the windshield wipers are inoperative in all modes, GO to PINPOINT TEST A
. If the windshield wipers only operate when high speed mode is selected, GO to PINPOINT TEST F . If the windshield wipers operate correctly, disregard this DTC. |
| B1131:08 | Wiper Motor Module: Bus Signal/Message Failure | If the windshield wipers are inoperative in all modes, GO to PINPOINT TEST A
. If the windshield wipers only operate when high speed mode is selected, GO to PINPOINT TEST F . |
| B12F7: 09 | Single Wipe Switch: Component Failure | INSTALL a new wiper/washer switch. REFER to WIPER/WASHER SWITCH . CLEAR the DTCs. REPEAT the self-test. |
| All other DTCs | - | REFER to STEERING COLUMN SWITCHES . |