LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2011 >> Edge SE, AWD >> Repair and Diagnosis >> Steering >> Steering Column >> Removal And Installation >> Heated Steering Wheel Module (HSWM) >> Removal and Installation
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Removal and Installation

  1. If a new Heated Steering Wheel Module (HSWM) is being installed, connect the scan tool and upload the module configuration information from the HSWM  . For additional information on configuration, refer to Programmable Module Installation (PMI) in MODULE CONFIGURATION .
  2. Remove the glove compartment. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
  3. Remove the 2 Remote Function Actuator (RFA) bracket screws and position the RFA module and bracket aside.
    Fig 1: Locating Remote Function Actuator (RFA) Bracket Screws
    G07397708Courtesy of FORD MOTOR CO.
  4. Disconnect the HSWM  electrical connector.
  5. Remove the 3 HSWM  screws and the HSWM  .
    • To install, tighten to 3 Nm (27 lb-in).
  6. To install, reverse the removal procedure.
    • If a new HSWM  was installed, it must be configured (using vehicle as-built data or module configuration information retrieved earlier in this procedure). For additional information on configuration, refer to PMI  in MODULE CONFIGURATION .
scientia non olet · About LEMON Manuals