LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2011 >> E 450 V10-6.8L >> Repair and Diagnosis >> Cruise Control >> Cruise Control Switch >> Service and Repair >> Cruise Control Deactivator Switch
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Cruise Control Deactivator Switch




Cruise Control Deactivator Switch













Removal

1. NOTICE: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with water.

NOTE: Make sure the master cylinder reservoir cap is secure before carrying out this procedure.

NOTE: Do not allow any foreign matter to enter the master cylinder port once the deactivator switch is removed.

Remove the cruise control deactivator switch.

- Disconnect the electrical connector.

Installation

1. NOTICE: Do not allow brake fluid to contact the electrical connector. Failure to follow this instruction may result in damage to the electrical connector or wiring.

Install the cruise control deactivator switch.

- Add a few drops of brake fluid to the fluid port on the threaded side of the switch before installing it.

- Tighten to 18 Nm (159 lb-in).

- Connect the electrical connector.





2. Check the master cylinder fluid level and adjust as necessary.

scientia non olet · About LEMON Manuals