Removal And Installation
WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
- Disconnect the mass air flow (MAF) sensor electrical connector.
- Remove the 2 bolts, the MAF sensor and discard the gasket.
- To install, tighten to 11 Nm (8 lb-ft).
- To install, reverse the removal procedure.
- Install a new gasket.
CAUTION:
Do not tamper with the MAF sensing elements located in the airflow bypass. Tampering may result in failure.
NOTE:
The MAF sensor module and body are calibrated and installed as a unit.