Fender Splash Shield

Fender Splash Shield

Removal and Installation

1. Loosen the running board bolts and lower the running board to access the front fender moulding pin-type retainer.
- To install, tighten to 23 Nm (17 lb-ft).

2. Remove the lower pin-type retainer from the front fender moulding.

3. Remove the 2 rear pin-type retainers from the front fender moulding.

4. Position the front fender moulding aside and remove the splash shield lower screw.





5. Remove the front splash shield screws.

6. Remove the front splash shield pin-type retainers.

7. Remove the front splash shield.

8. Remove the front fender splash shield.

9. To install, reverse the removal procedure.