Removal and Installation

All vehicles 

NOTE: Module configuration is only required if a new ACM is being installed.
1. Upload the ACM configuration to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in MODULE CONFIGURATION .
2. Remove the middle instrument panel center finish panel. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
3. Remove the 4 ACM screws.
   • To install, tighten to 2 Nm (18 lb-in) (navigation).
   • To install, tighten to 1 Nm (9 lb-in) (all except navigation).

     Navigation 

4. Disconnect the antenna and electrical connectors.

   All except navigation 

5. If equipped, remove the 4 screws and the ACM side support brackets.
NOTE: Only carry out this step if installing a new ACM.
6. Remove the 2 ACM brackets.

   All vehicles 

7. Remove the ACM.
8. To install, reverse the removal procedure.
   • Download the configuration information to the ACM. For additional information, refer to PMI in MODULE CONFIGURATION .