LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2007 >> Taurus SE >> Repair and Diagnosis >> Electrical >> Charging Systems >> Charging System - General Information >> Diagnostic Tests >> Charging System >> Component Tests >> Generator On-Vehicle Tests - Load Test
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Generator On-Vehicle Tests - Load Test

  1. Switch the tester to the ammeter function.
  2. Connect the positive and negative leads of the tester to the corresponding battery terminals.
  3. Connect the current probe to the generator B+ output terminal, circuit 36 (YE/WH).
  4. With the engine running at approximately 2,000 rpm, adjust the tester load bank to determine the output of the generator. Generator output should be greater than the graph shown below. If not, refer back to the pinpoint test or Go to Symptom Chart .
    5. Fig 1: Generator Output Graph
    GF0004527Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals