Ignition Coil: Service and Repair

IGNITION COIL-ON-PLUG

Engine Ignition - RH:

Engine Ignition - LH:

Exploded View

Removal and Installation

RH side

1. NOTE: The upper intake manifold must be removed to access the RH ignition coils only.

Remove the upper intake manifold.

Both sides
2. Disconnect the ignition coil electrical connectors.

3. NOTE: When removing the ignition coil-on-plugs, a slight twisting motion will break the seal and ease removal.

Remove the bolts and the ignition coils.
- To install, tighten to 15 Nm (11 lb-ft).

4. To install, reverse the removal procedure.
- Apply a small amount of dielectric grease to the inside of the ignition coil boots before attaching to the spark plugs.