Front Door Window Regulator

FRONT DOOR WINDOW REGULATOR

Special Tool(s):

Special Tool(s)

Removal and Installation
1. Remove the front door trim panel.
2. Position the watershield aside.
3. Connect the window control switch.
4. If necessary, connect the battery.







5. Remove the rivets.
- Lower the window enough to gain access to the door window glass rivets.







6. If removing only the front door window glass regulator assembly and motor, tape the window in the CLOSED position after removing the rivets.
7. Remove the 4 window regulator rivets.







8. Remove the 3 window regulator nuts.
- To install, tighten to 12 Nm (9 lb-ft).







9. Disconnect the electrical connector.
10. Remove the front door window regulator.
11. To install, reverse the removal procedure.