LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2006 >> Expedition RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 146 (Electronic Engine Control System) >> Removal And Installation >> Throttle Position (TP) Sensor >> Removal
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Throttle Position (TP) Sensor: Removal

WARNING: This page is about a different car, the 2005 Lincoln Navigator and 2005 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

    All vehicles 

  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .

    2. Navigator vehicles 

  2. Remove the air cleaner inlet pipe and the air cleaner assembly. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING .

    3. All vehicles 

  3. Disconnect the throttle position (TP) sensor electrical connector.
    4. CAUTION: Failure to remove the TP sensor screws in the following manner will result in damage to the screws. First loosen the screws 1-2 full turns using a hand tool and then use a suitable high speed driver to complete the removal.
  4. Remove and discard the 2 screws and the TP sensor.
scientia non olet · About LEMON Manuals