Steering Control Module: Service and Repair

Power Steering Control (PSC) Module

Removal and Installation
1. Remove the air cleaner assembly.
2. Remove the battery junction box (BJB) bracket nuts on the strut tower.
Position the BJB aside.
3. Disconnect the power steering control module electrical connectors.
4. Remove the 2 power steering control module nuts.
^ To install, tighten to 23 Nm (17 ft. lbs.).
5. Remove the power steering control module ground cable bolt.
6. Remove the power steering control module nuts from inside the vehicle.
^ To install, tighten to 23 Nm (17 ft. lbs.).
7. Remove the power steering control module.
8. To install, reverse the removal procedure.