LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2003 >> Windstar Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 1364 (Exterior Lighting System) >> General Procedures >> Front Fog Lamp Adjustment
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Front Fog Lamp Adjustment

WARNING: This page is about a different car, the 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Horizontal aim is not required for this vehicle and is not adjustable. Consult your state vehicle inspection center for recommended tolerance ranges for visual aiming.
  1. Before starting the fog lamp assembly adjustment:
    • check the tire inflation.
    • make sure there are no other loads in the vehicle other than a half tank of fuel.
    • make sure the vehicle is on level ground.
    • make sure the fog lamps and headlamps are clean.
    • make sure the headlamps are operating and are correctly aimed.
    2. NOTE: The vertical wall screen must be a minimum of 2.4-m (8-ft) wide.
    Fig 1: Identifying Vertical Wall Or Screen Level Surface Dimension
    G04645631Courtesy of FORD MOTOR CO.
  2. Park the vehicle on a level surface approximately 7.6 m (25 ft) from the vertical wall or screen directly in front of it.
  3. The correct visual aim for the fog lamps is with the top edge of the high-intensity zone 10 cm (4 in) below the horizontal center of the fog lamps.
    Fig 2: Identifying Visual Aim For Fog Lamps Is With Top Edge Of High-Intensity Dimension
    G04645632Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals