LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2003 >> Focus SVT, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 1111 (Electronic Engine Control System) >> Removal And Installation >> Knock Sensor (KS) >> Removal and Installation
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  3. Position the knock sensor (KS) heat shield aside.
    Fig 1: Locating Knock Sensor
    G03990667Courtesy of FORD MOTOR CO.
  4. Disconnect the KS electrical connector.
  5. Remove the bolt and the KS.
    • To install, tighten to 20 Nm (15 lb-ft).
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals