Cruise Control Servo Cable: Service and Repair

REMOVAL







1. Remove the bolts and the accelerator cable snow shield.







2. Separate the speed control cable from the intake manifold.
1 Disconnect the cable from the throttle linkage.
2 Depress the locking tabs and separate the speed control cable from the intake manifold.






3. Depress the locking tab and rotate the speed control cable cap to remove.







4. Disconnect the speed control cable from the speed control servo pulley and remove the speed control cable.
1 Gently push the retaining spring.
2 Disconnect the speed control cable slug from the speed control servo pulley.

INSTALLATION







1. To install, reverse the removal procedure.

NOTE: Make sure the rubber seal is fully seated onto the speed control cable cap