LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2002 >> Excursion 7.3 F, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1085 (Anti-Lock Brake System Control) >> Removal And Installation >> Brake Pressure Transducer >> Removal and Installation
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink water and induce vomiting. Get medical attention immediately. Failure to follow these instructions may result in personal injury.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with water.
  1. Disconnect the brake pressure transducer electrical connector.
  2. Remove the brake pressure transducer.
    • To install, tighten to 18 Nm (13 lb-ft).
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals