Test H: Off Switch Inoperative

Turn ignition switch to LOCK position. Disconnect Black 10-pin speed control servo/actuator harness connector C136. Speed control servo/actuator is located behind left front fenderwell. Using DVOM, measure resistance between speed control servo/actuator harness connector C136 terminals No. 5 (Light Blue/Black wire) and No. 6 (Dark Green/Orange wire). See Figure . Press speed control switch to OFF position. If resistance is 5 ohms or less, replace speed control servo/actuator. See REMOVAL & INSTALLATION  . If resistance is more than 5 ohms, replace speed control switch.