Ambient Light Sensor: Service and Repair

REMOVAL







1. Remove the defroster grille.
^ Disconnect the sunload/headlamp sensor electrical connector.

NOTE: Lift upwards on the rear edge of the defroster grille then slide rearward to remove.







2. Remove the light sensor amplifier.
1 Disconnect the light sensor amplifier electrical connector.
2 Remove the screws.
3 Remove the sensor.

CAUTION: To avoid damaging the light sensor amplifier electrical connector, carefully tilt the panel to expose the connector without stretching the wiring.

INSTALLATION
1. To install, reverse the removal procedure.