LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2000 >> Taurus SEL >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System Control >> Diagnostic Tests >> Test D: DTC B1484 - Brake Pedal Input Open Circuit
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Test D: DTC B1484 - Brake Pedal Input Open Circuit

  1. Check Stop lamps

    Press brake pedal and ensure stop lamps illuminate. If lights are not on, see AUTOLAMP SYSTEMS article in ACCESSORIES & EQUIPMENT. If lights are on, go to next step.

  2. Check ABS Control Module BOO_ABS PID

    Monitor ABS control module PID BOO_ABS, while pressing and releasing brake pedal. If ABS control module PID BOO_ABS indicates ON with brake pedal pressed and OFF when brake pedal is released, clear codes and repeat self-test. If display is not correct, go to next step.

  3. Check For Open Circuit

    Turn ignition off. Disconnect 30-pin connector from ECU. Measure voltage between ABS control module connector terminal No. 6 (Red/Light Green wire) harness side and ground while depressing brake pedal. See Figure . If voltage is more than 10 volts, replace ECU. Repeat self-test. If voltage is less than 10 volts, repair circuit. Clear codes and repeat self-test.
scientia non olet · About LEMON Manuals