Ignition Switch: Service and Repair

Removal
1. Disconnect the battery ground cable.





2. Pull the steering column opening cover off the lower instrument panel.





3. Note: For clarity, the driver side knee brace and the steering column opening reinforcement are not shown in the illustration. It is not necessary to remove these items to remove the ignition switch.

Disconnect the wiring harness from the ignition switch.





4. Remove the ignition switch screws and the ignition switch.

Installation





1. Note: When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 mi) or more to relearn the strategy.

To install, reverse the removal procedure.