Accessing Ford Specific OBD-II PIDs

WARNING: This page is about a different car, the 2002 Ford Pickup and 2002 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition off. Ensure test equipment is properly attached. Program NGS tester using the following steps:

Turn ignition switch to ON position or start engine and allow to idle.
Select VEHICLE & ENGINE SELECTION menu.
Select NEW VEHICLE, YEAR & MODEL.
Select DIAGNOSTIC DATA LINK.
Select AFCM-ALTERNATE FUEL CTRL MODULE (AFCM supports similar DTCs and PIDs as PCM, but may have an entirely different meaning).
Select PID/DATA MONITOR AND RECORD.
Select PIDs and press trigger on NGS tester.
Press START to begin monitoring. If PID value is not as specified, perform appropriate SYSTEM TEST.