Brake Discs
WARNING: This page is about a different car, the 2004 Ford RV Cutaway, 2004 Ford Econoline, 2004 Ford E450 Super Duty, and 2004 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Using an impact tool without a torque socket will lead to unevenly tightened lug nuts. This causes brake disc on-vehicle lateral runout and brake roughness.
NOTE:
It is generally not required to install new brake discs to address noise issues.
- Remove the brake disc. For additional information, refer to DISC & DRUM for front or rear disc brakes.
- Inspect the brake discs and measure the brake disc thickness in a minimum of 4 places around the circumference of the brake disc. Record the measurements.
- Install new brake discs if any thickness measurement is less than the minimum specification. For additional information, refer to DISC & DRUM for front or rear disc brakes.
- Install new brake discs if cracked. For additional information, refer to DISC & DRUM for front or rear disc brakes.
- Machine the brake discs if the diagnosis has revealed vibration in the steering wheel, seat, or pedal while braking. Heavily scored brake discs, similar to that caused by pads worn down to the backing plate, should also be machined. In order to machine, discs must be above the minimum thickness to machine specification. For additional information, refer to SPECIFICATIONS and BRAKE DISC MACHINING .