Pinpoint Test F - Alarm Indicator Light Does Not Work
- Start vehicle, then turn off. Disconnect Anti-Theft Control Module connectors. Connect a jumper wire between Anti-Theft Control Module connector C1, terminal No. 15 (Dark Blue/Light Green wire). See Figure . If light turns on, replace Anti-Theft Control Module and retest system. If light does not turn on, go to next step.
- Check 15-amp INT LPS fuse and anti-theft indicator bulb. If either are bad, replace and retest system. If fuse and bulb are good, repair circuit No. 54 (Light Green/Yellow wire) and/or circuit No. 343 (Dark Blue/Dark Green wire) and retest system.