LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 1996 >> Explorer 2D Utility, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 161 (Engine Controls - System/Component Tests - EEC-IV (5.8L)) >> Ignition Systems >> Notes
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Ignition Systems: Notes

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 1995 Ford RV Cutaway, 1995 Ford Pickup, 1995 Ford Econoline, 1995 Ford Cutaway, and 1995 Ford Club Wagon. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For additional information and descriptions, see IGNITION SYSTEMS in appropriate THEORY & OPERATION - ECC-IV article in the ENGINE PERFORMANCE section below.
IGNITION SYSTEM ACRONYMS (1)

Acronym Definition
BAT+ Or BAT (+) Battery Positive
BAT- Or BAT (-) Battery Negative
BOB Breakout Box
CCD Computer Controlled Dwell
CID Cylinder Identification
C1, C2, C3 Coil Drive (Coils 1, 2 & 3)
DI Distributor Ignition System
EI Electronic Ignition System (Distributorless)
ICM Ignition Control Module
IDM Ignition Diagnostic Monitor (Diagnostic Signal To PCM)
IGN GND Ignition Ground (Low Current Ground Reference)
KOEC Key On Engine Cranking (Testing Condition)
KOEO Key On Engine Off (Testing Condition)
KOER Key On Engine Running (Testing Condition)
PCM Powertrain Control Module
PIP Profile Ignition Pick-Up (Crankshaft Sensor Signal)
PWR GND Power Ground Circuit
SPOUT Spark Output (PCM Spark Control Signal)
VPWR Or VBAT Battery Power Or Battery Voltage
(1) Not all circuits and components are used in all systems.
IGNITION SYSTEM IDENTIFICATION

Application System
5.8L DI (CCD)