LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 1995 >> Mustang V6-232 3.8L >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Testing and Inspection >> Scan Tool Testing and Procedures >> Parameter Identification (PID) Access >> Accessing Generic OBDII PIDs >> With Generic Scan Tool
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

With Generic Scan Tool

These are general instructions for operating a generic scan tool. Refer to the manufacturer's manual for specific instructions.

- Perform the necessary vehicle preparation and visual inspection.

- Connect scan tool to DLC.

- Turn ignition key to the On position or START vehicle (depending on the pinpoint/diagnostic instructions for the data requested).

- Verify tool is connected and communicating properly (if necessary, enter the OBD II System Readiness Test to verify communication). On-Board System Readiness Test Access

- Go to the scan tool PID screen to access PIDs (no extended data entry should be required).

- View the requested information.

- When finished, turn ignition key to the Off position.

- Disconnect scan tool from vehicle.

scientia non olet · About LEMON Manuals