Ignition Coil: Service and Repair

REMOVAL
1. Disconnect spark plug wires from ignition coil.

NOTE: When removing wires from ignition coil, squeeze the locking tabs of coil wire retainer by hand. Twist and pull on boot until free.

2. Disconnect engine harness electrical connector from ignition coil.
3. Remove four ignition coil assembly retaining screws, then the coil.

INSTALLATION
1. Mount ignition coil to bracket.
2. Tighten retaining screws to specification.
3. Connect engine harness electrical connector to ignition coil.
4. Install spark plug wires.