LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 1994 >> Probe Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 125 (Clutches) >> Removal & Installation >> Clutch Assembly >> Installation
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Clutch Assembly: Installation

WARNING: This page is about a different car, the 1995 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install flywheel. Position clutch disc and pressure plate on flywheel. Align index mark on pressure plate with flywheel. Ensure dowel pins on flywheel are not bent, damaged or missing. Replace if necessary. Start pressure plate attaching bolts, but do not tighten. Align clutch disc using Clutch Aligner (T74P-7137-K).
  2. Tighten pressure plate-to-flywheel bolts evenly in crisscross pattern until all are tightened to specification. See TORQUE SPECIFICATIONS  . Before installing transmission, lubricate outside diameter of transmission front bearing retainer, inside groove of release bearing, clutch release shaft fingers, pivot ball and mating pocket on release shaft. To complete installation, reverse removal procedure.
NOTE: Re-use aluminum washers under attaching bolts to prevent galvanic corrosion.
NOTE: Lubricate yoke splines with Lubricant (ESA-MIC75-B).
scientia non olet · About LEMON Manuals