LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 1994 >> Bronco 5.8 H >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Engine Controls - System/Component Tests - Gasoline) >> Computerized Engine Controls >> Powertrain Control Module (Pcm) >> Power Circuits
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Power Circuits

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 1993 Ford Ranger, 1993 Ford RV Cutaway, 1993 Ford Pickup, 1993 Ford F-Super Duty, and 1993 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

Using a voltmeter, check for battery voltage between PCM terminal No. 1 (KAPWR) and ground. Check for battery voltage at terminals No. 37 and 57 (VPWR). If battery voltage is not present, power is not being supplied from EEC power relay. See CIRCUIT TEST B in appropriate TESTS W/CODES article in the ENGINE PERFORMANCE Section.

PCM LOCATION

Application Location
Aerostar Left Of Master Cylinder
Bronco & Pickup Below Brake Fluid Reservoir
Explorer & Ranger Behind Right Kick Panel
Van Right Fender Apron, Under Blower Motor
Fig 1: Identifying PCM 60-Pin Connector Terminals
G90I09354Courtesy of FORD MOTOR CO.