LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 1991 >> Bronco 4.9 Y, Standard, M5OD-R2 >> Repair and Diagnosis >> Steering >> Power Steering >> Steering System - Integral Power >> Overhaul >> Control Valve Housing >> Reassembly
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Control Valve Housing: Reassembly

  1. If tube seats were removed, coat with petroleum jelly and install with Tube Seat Installer (T74P-3504-M). Coat bearing and seal surface with petroleum jelly. Press bearing into housing using Installer (T65P-3524-A1) with metal covering rollers facing out. Bearing should rotate freely after installation.
  2. Coat new oil seal in power steering fluid. Drive seal, using Installer (T65P-3524-A1), metal side out into housing. DO NOT  fully seat seal. Remove Installer, place snap ring on seal and finish driving seal in until snap ring seats.
  3. Place dust seal in housing with dished rubber side out. Using Installer (T65P-3524-A1), press until seal is located behind undercut in input shaft. Apply generous amount of multi-purpose grease to area between seal lips.
scientia non olet · About LEMON Manuals