Junction Block: Removal
WARNING: This page is about a different car, the 2020 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Remove the passenger side instrument panel lower closeout. Refer to PANEL, SILENCER, LOWER, REMOVAL .
- Release the junction block release clip (1), roll down to access the back of the junction block (2).
- Disconnect the electrical connectors (4).
- Slightly push the junction block back and then roll forward to release the junction block from the bracket (3).