LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Fiat >> 2012 >> 500 Abarth >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Electronic Control Modules (Service Information) Except 500E) >> Standard Procedure >> Program The CTM (Convergence Telematics Module)
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Program The CTM (Convergence Telematics Module)

WARNING: This page is about a different car, the 2013 Fiat 500c and 2013 Fiat 500. However, it is still accessible from the selected car via links, so may be relevant.

When replacing any module not the replacement and programming order. For more information see the MODULE REPLACEMENT AND PROGRAMMING ORDER GUIDE  .

After verifying the proper replacement and programming order, follow the steps below to program the CTM.

  1. Connect the scan tool.
  2. Check vehicle for DTCs.
  3. Clear all stored DTCs.
  4. Turn car OFF then ON and confirm DTCs are gone.
  5. Go to CTM >> Misc. Functions >> Proxi Alignment

If required, continue to programming the next module.

scientia non olet · About LEMON Manuals