Test 99A - All Doors (Except Left Front) Fail To Lock & Unlock
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION
. For wiring diagrams, see appropriate article in ENGINE PERFORMANCE:
- WIRING DIAGRAMS - 3.3L
- WIRING DIAGRAMS - 3.5L
- Perform TEST VER-1 after each repair.
- Remove door unlock relay from junction block. See Figure . Junction block is located behind end cover, on left side of instrument panel. Go to next step.
- Using scan tool in ohmmeter mode, check resistance of door unlock relay connector terminal "A" (Pink/Black wire). If resistance is more than 10 ohms, repair open Pink/Black wire. If resistance is less than 10 ohms, go to next step.
- Check resistance of door unlock relay connector terminals "D" (Black wire) and "E" (Black wire). If resistance is more than 5 ohms in either wire, repair appropriate open Black wire. If resistance is less than 5 ohms, replace unlock relay.