Module, Anti-Lock Brake System: Installation: Installation

WARNING: This page is about a different car, the 2015 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Clean any debris off the mating surfaces of the HCU and ABS module.
NOTE:
When installing a new ABS module seal, do not use any type of lubricant.

Fig 1: ABS Module & Seal
Courtesy of CHRYSLER GROUP, LLC
If the seal (1) on the ABS module (2) are not new, replace them. The ABS module seal must be new to keep out moisture and debris; do not reuse the ABS module seal .

Fig 2: Antilock Brake Module (ABM) & Hydraulic Control Unit (HCU)
Courtesy of CHRYSLER GROUP, LLC
Align components and install the ABS module (1) on the HCU (2).

Fig 3: Integrated Control Unit & Mounting Grommets
Courtesy of CHRYSLER GROUP, LLC
Install the three ABS module to HCU mounting screws (3). Tighten to the proper specifications. Refer to SPECIFICATIONS .
Install the two ICU to bracket bolts and tighten to the proper specifications. Refer to SPECIFICATIONS .
Install the ICU in the vehicle. Refer to INTEGRATED CONTROL UNIT (ICU), INSTALLATION .