Diagnostic Test

KEY NOT PROGRAMMED
1. Turn the ignition on.
2. Using a scan tool, attempt to program the key(s) into the WCM.
  Was the programming of the key(s) successful?
  
  Yes
  - Programming of the key(s) was successful. Test complete.
  - Perform the WIRELESS CONTROL MODULE (WCM) VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Wireless Control (WCM) - Standard Procedure .
  No
  - Replace the ignition key and attempt to program it into the WCM. If the DTC resets, replace and program the Wireless Control Module in accordance with the Service Information.
    NOTE: If this vehicle is equipped with a Steering Column Lock Module, it must be replaced along with the WCM.
  - Perform the WIRELESS CONTROL MODULE (WCM) VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Wireless Control (WCM) - Standard Procedure .