LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, 4WD, Part Time >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Speed Control >> Servo >> Installation
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Speed Control: Servo: Installation

  1. Position servo to mounting bracket.
  2. Align hole in cable connector with hole in servo pin. Install cable-to-servo retaining clip.
  3. Insert servo mounting studs through holes in servo mounting bracket.
  4. Install servo mounting nuts and tighten to 8.5 N.m (75 in. lbs.).
  5. Connect vacuum line at servo.
  6. Connect electrical connector at servo.
  7. Connect servo cable to throttle body. Refer to CABLE  .
  8. Connect negative battery cable to battery.
  9. Before starting engine, operate accelerator pedal to check for any binding.
scientia non olet · About LEMON Manuals